"Roll Your Own" Binding Plug

Take any "female" servo HOUSING connector (it actually has the MALE pins in it), cut off so you have some wire to work with. Cut and strip the SIGNAL wire (white or orange) and connect to the NEGATIVE wire (black or dark brown), solder. Done. 

If you need the "male" to plug direct into the RX to bind, just make one for each by taking a short servo extension, cutting in half, and connecting wires as above. This would leave you with a male and female "binding" connector. CUT the RED + Power wire so that it can't be accidentally involved in anything!!!

ALWAYS a source of confusion, as the "male" housing that plugs into the "female" housing has the "Female" pin sockets which slide over the "Male" pins..... you would think someone was playing with us....but this is how it really is across all the RC connectors.

(thanks to onewasp on RCU for helping me clarify this)